You are Unregistered, please register to use all of the features of Twospoke.com    

Bike and Cycling Forum > Bike Forums > Mountain Biking >

Twin_T............2017 Trek Stache 7


Reply
 
LinkBack Thread Tools Display Modes
Old 09-16-2017, 02:21 PM   #31
cwtch
 
cwtch's Avatar
 
Join Date: Apr 2016
Posts: 2,135
Liked 3431 Times on 1466 Posts
Likes Given: 1

I was about to post and message you how to do that. Takes a spanner wrench on the non drive and just cinch it down. You can't within reason really over tighten it because it doesn't put pressure on the bearings. In other words lock it down tight and it will still spin free and easy without the side to side play.


cwtch is offline  
 
Reply With Quote Quick reply to this message
Old 09-16-2017, 03:01 PM   #32
i12ride
Spin Spin Spin
 
i12ride's Avatar
Bikes
 
Join Date: Feb 2013
Posts: 2,771
Liked 2855 Times on 1502 Posts
Likes Given: 1584

it can get too tight. while checking it out i just tightened from both sides and it did lock down on the bearings where wheel wouldn't spin freely. it has to be set just right and then locked with the silver cap nut thing that fills in between frame and adjuster nut on non drive side. need 2 wrenches ......thin 19mm and another 19 on same side to lock it in place. just like locking down bearing races on standard bolt on axle wheels.
__________________
I've lived on the edge long enough to have earned taking up a little extra space!
i12ride is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
2017 Whiteface Mt challenge rola643 Road Bikes 7 04-30-2017 09:14 PM
2017 Southern Cross (Lance Armstrong & Christian Vande Velde) Doc1 Mountain Biking 8 03-10-2017 02:24 PM
Tour Down Under 2017 rola643 Professional Cycling 2 02-17-2017 05:14 PM
First 2017 Ride, What a Disaster! Huffnpuff General Bike Discussion 7 01-05-2017 08:49 PM
TS Member Calendars 2017/2018 ?????? i12ride Off Topic 22 06-21-2016 11:51 PM