Last Activity:08-14-2015 12:01 PM
Likes Given: 58
193 Likes on 124 Posts
Posted in thread: What MTB Tires Are You Running? on 07-08-2015 at 12:17 AM
Maxxis Highroller 2
Posted in thread: Trek eMTB on 02-20-2015 at 10:39 PM
ebikes are for the lazy in my book. It is a moped
Posted in thread: Saddle on 12-18-2014 at 01:42 PM
+1 for the sit bone measurement. I always ran 155cm saddles and could never get comfortable
until I was measured. Turned out I needed a 143 and I have never looked back. Super comfortable
once I knew ...
Posted in thread: Dawes Lightning 1200 Review on 11-04-2014 at 02:31 PM
There is old world Dawes which was built in the UK and the new world Dawes when the name was
sold off and is now a BD, made in China line. The new Dawes lines usually have entry level or
no name compo...
Posted in thread: Bottom Bracket Question on 10-08-2014 at 01:22 PM
Better safe than sorry, I would buy a new one and use your existing BB for replacement parts
Posted in thread: Mall Racing in Russia on 10-01-2014 at 01:23 PM
cool vid, not much traction on the marble floors
Posted in thread: Single speed freehub question on 09-03-2014 at 01:46 PM
It all depends on the longevity that you are looking for. I have torpedoed one of these
freewheels. I have also used the Chinese freewheels with the same result. You cant rebuild
them, you just throw ...
Posted in thread: Saddle sores on 08-31-2014 at 03:35 AM
Custom molded saddles? Sounds awesome, but really really expensive.Sent from my iPhone using
Bike ForumNot if youre sponsored
Posted in thread: Saddle sores on 08-31-2014 at 02:10 AM
I do what is most comfortable for me and not what everyone else does. It may not be whats
comfortable for me. And, most professionals in the top ranks have saddles made specifically for
them from mold...
Posted in thread: Saddle sores on 08-31-2014 at 12:34 AM
Hygienics? The sores I get, warning, unpleasant, stop reading if you're smart, are not chaffing
but more like boils caused I think by blocked pores. I put on clean padded shorts every morning
but I lo...