what would all this cost?

Discussion in 'Road Bikes' started by norcalcycler, Dec 9, 2009.

  1. norcalcycler

    norcalcycler Guest

    XT 36h Hubs w/ Alex Adventurer Rims, DT Swiss Spokes
    XT Front Derailleur
    XT Rear Derailleur
    Dura Ace 9 Speed Bar End Shifters (Original bar end pieces included)
    Paul’s Components Thumbies Road Thumbies
    Race Face Turbine LP Crankset (110 Spacing, and 46-34-24t)
    Chris King Sotto Voce Headset
    Salsa Stem 80mm with 105 Degree Rise
    Salsa In Line Cross Levers
    Ritchey Anatomical Drop Bars
    Cane Creek V-Brake Aero Levers
    Avid Single Digit 7 V-Brakes w/ Kool Stop Pads
    Jagwire Stainless Cables w/ Kevlar Housing
    Cinelli Bar Tape (Double Wrapped) w/ Cat Eye Caps
    Schwalbe Kojak 700x35 Tires
    SKS Fenders
    Axiom Rear Rack
    Blackburn Front Rack
    Bontrager Seat Post (Not the Kona post shown in most of the pictures.)
    Vetta Italia Gel Saddle``
    Deore Cassette (11-13-15-17-20-23-26-30-34t)
    LX Bottom Bracket
    Shimano 600 Self Extracting Crank Bolts
    Basil Waterproof Saddle Bags (40 Liter Capacity Each)
    Planet Bike Bottle Cages x 3
    whats your best guess?
    thinking of putting it on a Surly LHT? +its also a commuter
  2. Industry_Hack

    Industry_Hack Total noob (& forum admin) Admin Staff Tavern Member

    That's a lot to ask. I can probably source it all for around half whatever MSRP is.

  3. Mootsguy

    Mootsguy A Red Headed Stepchild

    I would recommend the use of Ultegra Barcon shifters, way less money and they perform on a par with Dura Ace.

    Make sure you get the right Paul's thumbies, they make them for both mountain and road bikes.
  4. Industry_Hack

    Industry_Hack Total noob (& forum admin) Admin Staff Tavern Member

    That means that unless you're paying me to build your bike, it's an awful lot of work to figure out the total cost of all those parts. Even then, do you want MSRP, actual price at a shop, online prices (shipping?) or what someone with some connections could get it all for?
  5. IanHighfield

    IanHighfield New Member

    I was thinking the cost would be too much of my time. What are you doing? If I might ask.
  6. gatorguy

    gatorguy New Member

    That's a lot of work to ask someone to do. Google is your friend.